Texas Instruments X-Loader 1.41
Starting on with MMC 
Reading boot sector

1086232 Bytes Read from MMC 
Starting OS Bootloader from MMC...


U-Boot 1.3.3-svn333 (Sep 10 2009 - 16:47:29)

OMAP3530-GP rev 2, CPU-OPP2 L3-165MHz
OMAP3 DevKit8000 Board + LPDDR/NAND
DRAM:  128 MB
NAND:  256 MiB
In:    serial
Out:   serial
Err:   serial
Hit any key to stop autoboot:  0 
OMAP3 DevKit8000 #   
OMAP3 DevKit8000 # 
OMAP3 DevKit8000 # setenv bootargs console=ttyO2,115200n8 root=/dev/nfs nfsroot=192.168.1.104:/opt/DevKit/w3zeng_rootfs ip=192.168.1.103:192.168.1.104:192.168.1.1:255.255.255.0:devkit8000:eth0:off
OMAP3 DevKit8000 # saveenv
Saving Environment to NAND...
Erasing Nand...Writing to Nand... done
?40W DevKit8000 # reset

Texas Instruments X-Loader 1.41
Starting on with MMC 
Reading boot sector

1086232 Bytes Read from MMC 
Starting OS Bootloader from MMC...


U-Boot 1.3.3-svn333 (Sep 10 2009 - 16:47:29)

OMAP3530-GP rev 2, CPU-OPP2 L3-165MHz
OMAP3 DevKit8000 Board + LPDDR/NAND
DRAM:  128 MB
NAND:  256 MiB
In:    serial
Out:   serial
Err:   serial
Hit any key to stop autoboot:  0 
reading uImage

2394148 bytes read
reading ramdisk.gz

** Unable to read "ramdisk.gz" from mmc 0:1 **
## Booting kernel from Legacy Image at 80300000 ...
   Image Name:   Linux-2.6.38-rc1
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    2394084 Bytes =  2.3 MB
   Load Address: 80008000
   Entry Point:  80008000
   Verifying Checksum ... OK
   Loading Kernel Image ... OK
OK

Starting kernel ...

Uncompressing Linux... done, booting the kernel.

Add a code snippet to your website: www.paste.org